This is shown on the following page. It is always possible to upgrade or downgrade firmware at a later time using the bladeRF-cli program2. Posted by Kees de Groot at Information on re-flashing firmware while in this mode is available on the bladeRF wiki3. After pressing Enter, the firmware update will begin. Thanks a lot for all their efforts. Do not disconnect the bladeRF until the console displays a message noting that this process has completed.

Uploader: Nikolmaran
Date Added: 9 January 2012
File Size: 43.33 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 41526
Price: Free* [*Free Regsitration Required]

Information on re-flashing firmware while in this mode is available on the bladeRF wiki3.

It seems I did only get some noise in the file with the samples. Window, third-party applications or other systems e. Additionally, a driver may be installed at a later time using Zadig1.

Now the LEDs stopped blinking. Use Next to advance to the next screen. This is shown on the following page. A message is displayed, indicating that the bladeRF to update should be connected to the system.

CubicSDR | Cross-Platform and Open-Source Software Defined Radio Application

Click Next wwindows the desire option is selected. Creative Commons Attribution 4. Homework 8 SA, Spring Instructor: Dr Andrew Drew Wollin December 7, at 1: Progress messages will be displayed as the on-board flash is erased and reprogrammed. This is generally recommended, as firmware releases include feature updates and fixes.


As noted on wkndows installation screen, the v2. Nuand has new installer software for Windows In the blog at nuand. I agree that the Windows installer is very good.

bladerf windows install guide

Blaerf have a signal-generator that can put a signal up to 1 GHz on the antenna. Alternatively, it can be executed from cmd. I created a file with samples. Begin by running the installer executable.

Posted by Kees de Groot at If a driver has been selected for installation, a dialog will appear during this stage, providing information about the driver install progress. Once placed, double click the System block to specify that it wlndows implement a bladeRF Simulink object. Without this, Windows doesn’t even tell you it didn’t install the driver; it should at least do that.

I have a blog too. Makes it very easy to get BladeRF going.

Thus, until these issues have been further investigated and resolved, it is recommended that the libusb driver be used. They keep doing a great job.


As shown below, the block may be configured for a full-duplex configuration, with both RX and TX ports. If this is the first time installing bladeRF software on a machine, a driver must be installed.

Revision 1 2 Date Summary Initial revision for This installer can always be re-run to re install a driver, or install a different driver. I’ll experiment with some parameters like the gain, bandwidth, frequency and samplerate. As noted on this screen, some issues have been reported when using the CyUSB3 driver for applications utilizing transmit capabilities. OK, installation of the Windows software with the installer from Nuand is a breeze! Documents Flashcards Grammar checker.